When enabled, the ruler’s lines turn purple, and the icon shows a blue square grid. On the icon, tap the bottom right square. You can enable snapping to the entire perspective ruler by tapping the snap toggle icon that appears when a perspective ruler is selected with the Object tool. Toggling the snap settings Snapping to the entire perspective ruler However, when snapping to a vanishing point added separately from the perspective, the setting will be disabled. The Ratio setting will be reflected if it is turned on in the Tool Property palette. When drawing a rectangle, ellipse, or other shape, the angle cannot be adjusted even if Adjust angle after rotating (check) is turned on in the Tool Property palette. Snap does not work for intersections that are diagonal. Straight lines and Polylines can snap to a grid if the intersecting points are drawn along a perspective ruler. Note that some settings will be disabled when snapping to figures and polylines to a perspective ruler. You can use the Figure, Frame Border, Balloon, and Selection tools to draw shapes that follow the perspective ruler. If dragging to the start position does not redraw the line, you can turn this setting on in the Preferences dialog > Ruler/Unit > When snapping to perspective ruler, reset drawing direction by returning to start point.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |